Take your sub micro servo and cut off the plug with a small portion of the servo extension. Solder 240mm light weight small gauge servo lead to the servo using shrinking tube on each wire. Take one wing panel and cut the covering at the servo opening.
Traduction
The servo shaft should be located closer to the control surface to allow shoder pushrod.
Do the same with the other wing panel.
Traduction
Trim neckline seam allowances and understitch them to inner yoke panel. Finish bottom raw edge of inner yoke panel. Pin and stitch bottom edge of outer yoke panel to top edge of garment, right sides together, alining notches.
Traduction
